HOME IMPROVEMENT Index
Appliances
Basement
Bathrooms
Bedrooms
Cleaning
Contractors
Doors
Driveways & Paths
Duct Tape
Electrical Systems
Family Room
Fences & Gates
Fireplace
Floor Coverings
Furniture
Handles, Knobs & Hinges
Help on the Homefront
Home Energy Efficiency
Home Office
Homeowner in Process
House Exterior
Indoor Pests
Kitchens
Lighting
Outdoor Equipment
Outdoor Structures
Painting
Plumbing
Safety
Sports-Related Additions
Staining
Stairs
Storage
Tools
Utility Room
Walls & Ceilings
Windows

BEST OF
HOME IMPROVEMENT
Flooring
Decks
Mold Quiz
Home Safety
Tiling Techniques
Lighting Solutions
Weekend Projects
DIY to the Rescue
Home Renovations
Bathroom Makeover
Kitchen Renovations
Ultimate Media Room
Be Your Own Contractor

SPONSOR LINKS

  • Rockin' Chair
  • A salon chair becomes a rockin' chair.
    From "From Junky to Funky"
    episode DFJF-310


    Host Samantha Gleisten creates a unique chair with a place to store a guitar.

    advertisement


    PHOTO
    Materials:

    salon dryer chair
    fabric
    wood scraps
    1x2 oak
    wood glue
    sandpaper
    stain
    polyurethane
    spray glue
    power drill
    chop saw
    circular saw
    band saw

    PHOTO

    Figure A
    1. Unscrew the hair dryer, arm rests, seat, and back rest from the chair.

    2. Remove the old fabric from the seat and back rest (figure A). Stretch new fabric over the cushions, and then staple in place along the backside. Reattach the seat back and bottom.

    3. Cut sections of 1x2 blocking with a chop saw to run along the sides of the chair interior to support the new bottom and back panels.

    4. Measure and cut a plywood panel for the bottom and back of the chair using a circular saw.

    5. Pre-drill, wood glue and screw the blocking in place, and then attach the new back and bottom panels.

    6. Mark a "C" shaped outline on stainable scrap wood which will fit behind the chair back and hold the two guitars in place. The piece should be the same overall width as the back of the chair--and about twice as deep.

    PHOTO

    Figure B
    7. Cut the guitar holder out using a band saw (figure B).

    8. Place the piece on top of the back of the chair with the opening facing outward. Mark the piece from the bottom to make cutouts to allow the guitar holder to slide into the back, mounting flush with the sides and top of the chair back.

    9. Sand and stain the guitar holder, and then apply a polyurethane finish. Attach a strip of felt to the inside edge of the guitar holder so it will not scratch the guitars.

    10. Cover the sides of the chair with new fabric (figure C), and then attach with a staple gun on the inside. Finish with some upholstery tacks on the front.

    11. Cover the inside of the chair back with faux fur (figure D), and then spray glue in place.
    Photo

    Figure C

    Photo

    Figure D


    12. Attach the guitar holder by pre-drilling and screwing in through the sides of the chair back.

    Project Expense:

    Hair salon chair: Free
    Fabric: $32
    Wood, materials: $20

    Total: $52


    RESOURCES :

    The Brown Elephant
    Website: www.howardbrown.org/hb_brownelephant.asp

  • ALSO IN THIS EPISODE: